I'm unable to capture any of the objects in a website that was built using Angular ng containers. I'm using Automation Anywhere 11.3.0.0.
Page 1 / 1
Hello @Chamod Rathnayake ,
This is Dhwanit Parekh from Automation Anywhere Technical Support team.
Try upgrading your control room to more latest version like 11.3.5.x or Automation 360 v.25
That should ideally help, as a lot more use cases have been covered and a lot bugs have been fixed with the latest versions.
Upgrade Guide Lines From Previous V11.X.X To V11.3.X.X
Regards,
Dhwanit Parekh
Hi Dhwanit,
Thank you for the reply. I have installed the latest V11 version which is V11.3.5.6 but still unable to capture the objects. Is there any alternative way instead of Automation 360 v.25?
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.