Good morning,
Any one is getting an error at time of inserting a variable ?
I am unable to insert them… select any action and at time of inserting the variable, take some time and get a new screen for refresing. when done, get again the bot screen but at the original state.
See the viedo attached
Hi
Checkout below updates from AA, keep an eye on below KB to get latest updates.
https://apeople.automationanywhere.com/s/article/A360-UI-getting-an-error-code-STATUS-STACK-OVERFLOW-when-clicking-the-drop-down-button-on-the-bot-edit-page
Summary
Following the release of the new Google Chrome Browser version v124.x (124.0.6367.60 or 124.0.6367.61) and Edge browser version v124.x (124.0.2478.51), intermittent problems have been observed when clicking the dropdown button ▼ in the Automation 360 bot editor window on A360.x Control Room versions. Below error pops up "Aw Snap! something went wrong while displaying the website":
Note: The problem may manifest in any Bot Editor window of A360 Control Room when a drop-down is selected.
Cause
Resolution/Workaround
If you encounter this intermittent error, we recommend you to
Until the definitive solution is provided, we advise postponing the upgrade of Google Chrome browser to version 124.x (124.0.6367.60 or 124.0.6367.61) and Edge browser to 124.x (124.0.2478.51).
Additional Information
As Google Chrome version v124.x and Edge version v124.x is introduced this week, we've noticed instances where interactions with UI dropdowns in the Automation 360 bot editor window can trigger the appearance of the Chrome "Aw, Snap!" page, as shown in the attached screenshot. This occurrence obstructs users from completing their intended UI actions, accompanied by the "STATUS_STACK_OVERFLOW" error code.
Thks for your reply !!!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.